- Features
- Specifications
- Documents
Warranty Length
- 6 Years Limited Tank and Component Parts
Features
- Direct vent design one-pipe, dual-channel draws all make-up air from outside the home, eliminating problems caused by insufficient indoor ventilation, all units are FVIR compliant
- Horizontal air intake and venting on all models up to 80 in from outside wall with no electrical power needed
- Intelligent control logic - The internal microprocessor provides enhanced operating parameters and tighter differentials for precise sensing and faster heating response to optimize performance
- Uses a thermopile to generate the power needed to operates the electronic gas control without requiring an external power source
- The electronic gas control incorporates an LED status indicator that monitors system operation and service diagnostics
- Green Choice® gas burner - Patented "Eco-Friendly" design reduces NOx emissions by up to 33% and complies with low- NOx emission requirements of less than 40 ng/J
- Dynaclean™ diffuser dip tube - Helps reduce lime and sediment build up and maximizes hot water output, made from long-lasting PEX cross-linked polymer
- Coregard™ anode rod - Our anode rods have a stainless steel core that extends the life of the anode rod allowing superior tank protection for longer than standard anode rods
- Pushbutton piezo ignitor makes lighting the pilot fast and easy with one-hand pushbutton spark ignition
- Heat trap nipples Factory installed for faster installation
- Enhanced-flow brass drain valve - Our residential water heaters have a solid brass, tamper resistant, enhanced-flow, ball type, drain valve
- Uses a standard female hose fitting that allows for fast and easy draining during maintenance
- Designed for easy operation, this valve includes an integral screwdriver slot that features a 1/4 turn (open/close) radius, which not only permits full straight-through water flow but also a quick and positive shut off
- Certified for sea level to 7700 ft elevation
Standard Approvals
- CSA Design Certified
- Listed according to ANSI Z21.10.1-CSA 4.1 Standards governing storage tank-type gas water heaters
- Meets UBC
- CEC and HUD National Code
- Meets the thermal efficiency and standby loss requirements of the US Department of Energy and Current Edition of ASHRAE/IESNA 90.1
- Complies with the Federal Energy Conservation Standards effective April 16
- 2015
- in Accordance With The Energy Policy and Conservation Act (EPCA)
Dimensions:
22 in Dia x 74 in H
Energy Factor:
0.61
Fuel Type:
Natural Gas
Gas Connection:
1/2 in
Heating Capacity:
47000 Btu/hr
Height:
73.0"
Ignition Type:
Piezo Pushbutton
Length:
31.5"
Pressure Rating:
150 psi
Recovery Rate:
51 gph at 90 deg F
Series:
GDVT-50L
Tall or Short:
Tall
Tank Capacity:
50 gal
Ultra Low NOx:
No
Vent Type:
Direct
Water Connection:
3/4 in MNPT
Width:
23.5"