- Features
- Specifications
- Documents
Features
- Corrosion-resistant, powder coated epoxy finish
- No sheet metal parts to rust or corrode
- Stainless steel screws, switch arm, guard and handle
- No screens to clog, watertight, neoprene square ring between motor and pump housing
- Solid, buoyant, polypropylene float, oil filled, hermetically sealed, automatic reset thermal overload protected motor
- Upper and lower sleeve bearings running in bath of oil, Entire unit pressure-tested after assembly, carbon and ceramic shaft seal
- Watertight and dust tight, permanently oiled bearings
- Cast iron switch case, motor and pump housing, engineered thermoplastic base, glass filled, plastic impeller with metal insert
- Entire unit pressure-tested after assembly
- Class B insulation, 7-1/4 in/3 in auto On/Off points
- 1/2 in spherical solid handling, 9 ft cord, oil filled cooling
- Cast iron cap, motor and pump housing, base, carbon and ceramic mechanical seals, engineered plastic impeller, stainless steel hardware, neoprene gasket
- AISI 1215 cold roll steel motor shaft
- Single phase, shaded pole, 3 wire cord and plug
- 1-1/2 in NPT discharge
Standard Approvals
- CSA/US Certified
- SSPMA Certified
- UL Listed
Amperage Rating:
9.7 A
Bearing Type:
Sleeve
Cord Type:
3-Wire
Flow Rate:
43 gpm
Frequency Rating:
60 Hz
Horsepower:
3/10 hp
Impeller Type:
Non-Clogging Vortex
Material:
Cast Iron
Maximum Head:
19-1/4 ft
Motor Speed:
1550 rpm
Outlet Size:
1-1/2 in
Phase:
1 ph
Temperature Rating:
130 deg F
Voltage Rating:
115 VAC