- Features
- Specifications
- Documents
Features
- Float operated 2-pole mechanical switch
- Durable cast construction, ASTM Class 25 cast iron switch case and pump housing
- Non-clogging vortex impeller design, engineered plastic impeller with metal inserts (1 ph)
- Not affected by materials normally found in drainage and sewage pumps
- Stainless steel screws, bolts, handle, guard, arm and seal assembly
- Neoprene square ring and gasket
- Oil filled, hermetically sealed motors
- Oil-lubricated bearings
- Carbon and ceramic shaft seal
- Corrosion-resistant, powder coated epoxy finish
- Completely submersible
- Watertight and dust-tight
- Automatic reset thermal overload protection (1 ph only)
- 12 in on point, 4 in off point
- High water alarms available
- 10 in auto/15 in non auto, 3-wire neoprene cord and plug
- Cap/motor housing/pump housing cast iron, base cast iron or engineered plastic
- Upper and lower sleeve bearing
- Engineered plastic with metal insert impeller, Stainless steel hardware, AISI 1215 cold rolled steel motor shaft, Neoprene gasket
- Submersible sewage/effluent or dewatering pump
Standard Approvals
- cCSAus Certified
- CSA C22.2 108
- SSPMA Certified
- UL 778
Amperage Rating:
10.4 A
Bearing Type:
Sleeve
Cord Type:
3-Wire Neoprene
Enclosure Type:
Auto Reset Thermal Overload
Flow Rate:
128 gpm
Frequency Rating:
60 Hz
Horsepower:
1/2 hp
Impeller Type:
Non-Clogging Vortex
Material:
Cast Iron
Maximum Head:
21-1/2 ft
Motor Speed:
1750 rpm
Outlet Size:
2 or 3 in NPT
Phase:
1 ph
Temperature Rating:
130 deg F
Voltage Rating:
115 VAC