Cart ()
{0} items in cart
Sign In
Lancaster Water Group
LANCASTER® Hydro-Force™ 2-2LSJ7513-2 Survivor® J Submersible Well Pump With Hydro-Force™ 2-Wire Motor, 2 Wires, 230 VAC, 1 ph, 400 ft Max Suction Lift, 3/4 hp Power Rating
Lancaster Water Group

LANCASTER® Hydro-Force™ 2-2LSJ7513-2 Survivor® J Submersible Well Pump With Hydro-Force™ 2-Wire Motor, 2 Wires, 230 VAC, 1 ph, 400 ft Max Suction Lift, 3/4 hp Power Rating

BrandLancaster Water Group
MFR Part No22LSJ75132
TSCO Part Number340166

Features

  • Fluted polyurethane bearing at top end of shaft, excellent abrasion and wear resistance
  • Stainless steel cable guard for maximum cable protection, attached with stainless steel screws
  • Balanced PTFE impregnated Impellers made of glass-filled thermoplastic, provide for lower friction for longer pump life
  • Stainless steel hex shaft with slotted end for test turning
  • Fully enclosed, glass-filled thermoplastic diffusers and stage plates with stainless steel wear surfaces, each stage is complete with an individual composite thrust washer for extra protection
  • Heavy wall, high quality stainless steel pump casing sized inside for perfect stage alignment
  • Stainless steel screen, cannot snap off during installation
  • Glass-filled Noryl™ discharge head with field replaceable fluted Internal check valve, molded jug handles, no need for safety cable adapter, 1/2 to 1-1/2 hp models
  • Assembled pump stage are laminated phenolic thrust washer on top of every stage provides down-thrust protection and axial sealing for the impeller inside the next stage above
  • Inside a pump stage - Diffuser with stainless steel seal/wear surfaces for upper impeller hub, impeller eye surrounding lower hub, stage plate with stainless steel seal/wear surface for impeller eye
  • 4 in encapsulated submersible motors
  • Equipped with lightning arresters
  • Split-phase induction run (IR) design with built-in electronic starter connected in series to a high resistance auxiliary start winding - no capacitor required - electronic starter controls disengagement of start winding as a function of starting time and starting voltage
  • Stator filled with special epoxy resin and hermetically sealed for a better insulation of the winding and a greater heat exchange
  • Rotor and thrust bearings lubricated by water mixed with propylene glycol
  • Built-in check valve for restoring of cooling liquid (well water) as needed
  • Built-in lightning arresters providing surge protection
  • Built-in automatic reset overload providing thermal (overheat) protection caused by high amperage and/or inadequate motor cooling
  • AISI 304 stainless steel motor frame shell, stator ends and liner, hermetically sealed for maximum corrosion resistance
  • AISI 303 stainless steel splined shaft end

Standard Approvals

  • ANSI/NSF 61 (Health Effects)/372 (Lead Content)
  • UL Listed